5-9
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Chapter 5 Network Management
Using the Association Table
Performing a Ping
Follow these steps to ping the device described on the Station page:
Step 1 To customize the size and number of packets sent during the ping, enter the
number of packets and size of the packets in the Number of Pkts. and Pkt. Size
fields.
Step 2 Click Ping.
The ping runs using the values in the Number of Pkts. and Pkt. Size fields, and a
ping window appears listing the test results. To run the ping again, click Test
Again. Figure 5-3 shows a ping window.
Figure 5-3 Ping Window
Performing a Link Test
Follow these steps to perform a link test between the access point and the device
described on the Station page:
Step 1 To customize the size and number of packets sent during the link test, enter the
number of packets and size of the packets in the Number of Pkts. and Pkt. Size
fields.
Step 2 Click Link Test.
The link test runs using the values in the Number of Pkts. and Pkt. Size fields.
To Next Page
Loading...
Need help?
General
