Chapter 9 Diagnostics and Troubleshooting
Using Diagnostic Pages
9-10
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Configuration Information
• The top row of the Configuration section of the table contains a Set Properties
link that leads to the Ethernet Hardware page.
• Status of “fec0”— “Fast Ethernet Controller” is part of Motorola's naming
convention for the Ethernet device used by the access point. This field
displays one of the three possible operating states for the port. The added term
“primary” identifies the port as the primary port for the access point.
Operating states include:
–
Up—The port is operating properly.
–
Down—The port is not operating.
–
Error—The port is in an error condition.
• Maximum Rate (Mb/s)—Maximum rate of data transmission in megabits per
second.
• IP Address—The IP address of the port.
• MAC Address—The unique identifier assigned to the access point by the
manufacturer.
• Duplex—The port’s duplex setting, either half or full.
Receive Statistics
• Unicast Packets—The number of packets received in point-to-point
communication.
• Multicast Packets—The number of packets received that were sent as a
transmission to a set of nodes.
• Total Bytes—Total number of bytes received.
• Total Errors—Total number of packets determined to be in error.
• Discarded Packets—Packets discarded due to errors or network congestion.
• Forwardable Packets—Packets received by the port that were acceptable or
passable through the filters.
• Filtered Packets—Packets that were stopped or screened by the filters set up
on the port.
• Packet CRC Errors—Cyclic redundancy check (CRC) errors that were
detected in a received packet.
To Next Page
Loading...
Need help?
General
