9-23
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Chapter 9 Diagnostics and Troubleshooting
Using Command-Line Diagnostics
• Refcnt—the number of hosts referencing this address
• Use—number of packets forwarded
• Interface—one of four possible interfaces:
–
emac0 for Ethernet
–
awc0 for internal radio
–
awc1 for external radio
–
lo0 for internal loopback
Follow the steps in the “Entering Diagnostic Commands” section on page 9-20 to
open the CLI and enter the :vxdiag_arpshow command.
0x8 Host or net is unreachable.
0x10 Created dynamically (by redirect).
0x20 Modified dynamically (by redirect).
0x40 Message confirmed.
0x80 Subnet mask is present.
0x100 Generate new routes on use.
0x200 External daemon resolves name.
0x400 Generated by ARP.
0x800 Manually added (static).
0x1000 Just discard packets (during updates).
0x2000 Modified by management protocol.
0x4000 Protocol-specific routing flag.
0x8000 Protocol-specific routing flag.
Table 9-2 Flag Definitions
Flag Value Definition
To Next Page
Loading...
Need help?
General
