Chapter 9 Diagnostics and Troubleshooting
Checking Basic Settings
9-42
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Note Draft standard 8 is the default setting in firmware version 11.05 and earlier, and
it might remain in effect when you upgrade the firmware to version 11.06 or later.
Check the setting on the Authenticator Configuration page in the management
system to make sure the best draft standard for your network is selected.
Use the Authenticator Configuration page to select the draft of the 802.1x
protocol the access point’s radio should use. Follow these steps to set the draft for
your access point:
Step 1 Browse to the Authenticator Configuration page in the access point management
system.
a. On the Summary Status page, click Setup.
b. On the Setup page, click Security.
c. On the Security Setup page, click Authentication Server.
Step 2 Use the 802.1x Protocol Version (for EAP authentication) pull-down menu to
select the draft of the 802.1x protocol the access point’s radio should use. Menu
options include:
PC/PCI cards 4.23 — x —
PC/PCI cards 4.25 and later —— x
WGB34x/352 8.58 — x —
WGB34x/352 8.61 or later —— x
AP34x/35x 11.05 and earlier — x —
AP34x/35x 11.06 and later
2
— xx
BR352 11.06 and later
1
— xx
1. Functionality in Draft 10 is equivalent to the functionality in Draft 11, the
ratified draft of the 802.1X standard.
2. The default draft setting in access point and bridge firmware version 11.06
and later is Draft 10.
Table 9-4 802.1x Protocol Drafts and Compliant Client Firmware (continued)
Firmware Version Draft 7 Draft 8
Draft
10
1
To Next Page
Loading...
Need help?
General
