Chapter 9 Diagnostics and Troubleshooting
Resetting to the Default Configuration
9-44
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Step 3 In the Connection Description window, enter a name and select an icon for the
connection and click OK.
Step 4 In the Connect To window, select the port to which the cable is connected and
click OK.
Step 5 In the Port Settings window, enter the following settings:
• 9600 baud,
• 8 data bits,
• No parity,
• 1 stop bit, and
• No flow control
Step 6 Click OK, and press Enter.
Step 7 When the Summary Status screen appears, reboot the access point by unplugging
the power connector and then plugging it back in.
Step 8 When the access point reboots and the Summary Status screen reappears, type
:resetall, and press Enter.
Step 9 Type yes, and press Enter to confirm the command.
Note The resetall command is valid for only 2 minutes immediately after the access
point reboots. If you do not enter and confirm the resetall command during that 2
minutes, reboot the access point again.
Step 10 After the access point reboots and the Express Setup screen appears, reconfigure
the access point by using the terminal emulator or an Internet browser.
To Next Page
Loading...
Need help?
General
