3-15
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Chapter 3 Configuration
Filter Setup
Note If you plan to disallow traffic to all MAC addresses except those you
specify as allowed, put your own MAC address in the list of allowed MAC
addresses. If you plan to disallow multicast traffic, add the broadcast
MAC address (ffffffffffff) to the list of allowed addresses.
Step 3 Click Allowed to pass traffic to the MAC address or click Disallowed to discard
traffic to the MAC address.
Step 4 Click Add. The MAC address appears in the Existing MAC Address Filters list.
To remove the MAC address from the list, select it and click Remove.
Tip You can create a list of allowed MAC addresses on an authentication server on
your network. Consult the “Setting Up MAC-Based Authentication” section on
page 4-28 for instructions on using MAC-based authentication.
If you intend to list allowed MAC addresses on an authentication server, select yes
for the Look up MAC Address on Authentication Server if not in Existing Filter
List option.
Step 5 Click OK. You return automatically to the Setup page.
Step 6 Click Advanced in the AP Radio row of the Network Ports section at the bottom
of the Setup page. The AP Radio Advanced page appears. Figure 3-9 shows the
AP Radio Advanced page.
To Next Page
Loading...
Need help?
General
