Chapter 3 Configuration
Server Setup
3-46
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Simple Network Time Protocol
Select Enabled or Disabled to turn Simple Network Time Protocol (SNTP) on or
off. If your network uses SNTP, select Enabled.
Default Time Server
If your network has a default time server, enter the server’s IP address in the
Default Time Server entry field.
The Current Time Server line under the entry field reports the time server the
access point is currently using.
Note The DHCP or BOOTP server can override the default time server.
GMT Offset (hr)
The GMT Offset pull-down menu lists the world’s time zones relative to
Greenwich Mean Time (GMT). Select the time zone in which the access point
operates.
Use Daylight Savings Time
Select yes or no to have the access point automatically adjust to Daylight Savings
Time.
Manually Set Date and Time
Enter the current date and time in the entry fields to override the time server or to
set the date and time if no server is available.
When entering the date and time, use forward-slashes to separate the year, month,
and day, and use colons to separate the hours, minutes, and seconds. For example,
you would enter 2001/02/17 for February 17, 2001, and 18:25:00 for 6:25 pm.
To Next Page
Loading...
Need help?
General
