3-61
Cisco Aironet 1200 Series Access Point Software Configuration Guide
OL-2159-01
Chapter 3 Configuration
Association Table Display Setup
• Parent—A wireless client device’s parent device, which is usually an access
point.
• Device—A device’s type, such as a 350 series access point or a PC Client
Card. Non-Aironet devices appear as “Generic 802.11” devices.
• SW Version—The current version of firmware on a device.
• Class—A device’s role in the wireless LAN. Classes include:
–
AP—an access point station.
–
Client or PS Client—a client or power-save client station.
–
Bridge, Bridge R—a bridge or a root bridge.
–
Rptr—a repeater access point.
–
Mcast—a multicast address.
–
Infra—an infrastructure node, usually a workstation with a wired
connection to the Ethernet network.
Packets To/From Station
Use these settings to display packet volume information in the Association Table.
Select Total to display the total number of packets to and from each station on the
network.
Select Alert to display the number of alert packets to and from each station on the
network for which you have activated alert monitoring. Select the Alert checkbox
on a device’s Station page to activate alert monitoring for that device. See the
“Using Station Pages” section on page 5-3 for details on Station pages.
The Total and Alert selections both add a column to the Association Table.
Bytes To/From Station
Use these settings to display byte volume information in the Association Table.
Select Total to display the total number of bytes to and from each station on your
wireless network. Select Alert to display the number of alert bytes to and from
each station on the wireless network. Both selections add a column to the
Association Table.
To Next Page
Loading...
Need help?
General
