Coastcom D/I Mux III System User Manual

Chapter 4. Configuration and Operation
159
VR - Viewing Software Revision Status
From the MCU Main Menu, enter the VR command to View the Revision number of the current MCU
operating system software,. The revision screen is then displayed as depicted in Figure 4-69. During
this display process, the CCU may not be accessed until communication is re-established. Upon
completion of the display, when the CCU Status message reads “Executing program”, the system has
returned to normal operation.
] VR
17:02:28 ----------- [ Revision Levels ] ------------ 06/08/96
MCU System Software: Rev. 1.3
CCU Permanent Loader: Rev. 1.3
CCU Program (available to load): Rev. 1.3
CCU Program (now loaded on CCU): Rev. 1.3
CCU Status: Initializing
--------------------------------------------------------------
] VR
17:02:44 -----------[ Revision Levels ]-------------- 06/08/95
MCU System Software: Rev. 1.3
CCU Permanent Loader: Rev. 1.3
CCU Program (available to load): Rev. 1.3
CCU Program (now loaded on CCU): Rev. 1.3
CCU Status: Executing program
Figure 4-69. Viewing the Software Revision Status

Coastcom D/I Mux III System Specifications

General

Brand	Coastcom
Model	D/I Mux III System
Category	Multiplexer
Language	English