PowerConnect B-Series FCX Web Management Interface User Guide 53
53-1002268-01
Configuring stack ports
4
The Configure Unit Priority window contains the following information.
Additional information you can configure or view includes:
• Show priority
• Add module (refer to page 56)
Configuring stack ports
Select Configure > Stack > Stack-Ports to configure a stack. Click Modify to modify the
configuration of a port. Click Apply to save your configuration.
FIGURE 35 Configuring stack ports
When you assign an unused ID to a new stack unit, once this unit is reset, it assumes the new ID. All
configuration information related to the previous unit that used the ID is deleted. The Active
Controller learns the configuration for the new unit (instead of creating an interface configuration for
the new unit).
If the configuration for a unit being replaced does not match the new unit type, the Active Controller
removes the unit configuration and associated interface configuration.
You can also view details of Show Stack Details, Show Stack Modules, and Add Module. For more
information on adding a module, refer to page 56.
Unit ID The stack identification number for this unit.
Priority A number from 0 to 255 (255 is the highest priority).
To Next Page
Loading...
Need help?
General