Revision December, 2014 2-1
Chapter 2 Installation
2.1 Notes
Please pay special attention to the followings:
1) Do not strain the cable connection between the servo drive and the servo motor.
2) Make sure each screw is tightened when fixing the servo drive.
3) The motor shaft and the ball screw should be parallel.
4) If the connection between the servo drive and the servo motor is over 20 meters, please
thicken the connecting wire, UVW as well as the encoder cable.
5) Tighten the fixed four screws of the motor.
2.2 Ambient Conditions of Storage
Before the installation, this product has to be kept in shipping carton. In order to retain the
warranty coverage and for the maintenance, please follow the instructions below when
storage, if the product is not in use temporally:
Store the product in a dry and dust-free location.
Store the product within an ambient temperature range of -20 ℃ to +65 ℃.
Store the product within a relative humidity range of 0% to 90% and a non-condensing
environment.
Avoid storing the product in the environment of corrosive gas and liquid.
It is better to store the product in shipping carton and put it on the shelf or working
platform.
To Next Page
Loading...
Need help?
General
