Delta AX Series User Manual

AX-Series Motion Controller Instructions Manual Chapter 2
400
 Example
 This example shows how to use DMC_GetCamSlaveData function blocks to get the cam table master axis position
and the corresponding position of slave axis.
 Timing Diagram
 The figure above shows the changes of master and slave axis when the cam table runs for a cycle.
 Input 180 for DMC_GetCamSlaveData.lrCamPos (master axis position is 180), and then you can know that
when the master axis runs to 180, the slave axis position will be 360.
Master
Axis Positon
0
Slave
0
180
360

Delta AX Series Specifications

General

Brand	Delta
Model	AX Series
Category	Controller
Language	English