Digi XBee3 XB3M1 User Manual

AT commands MicroPython commands
Digi XBee3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide
189
MicroPython commands
The following commands relate to using MicroPython on the XBee Smart Modem.
PS (Python Startup)
Sets whether or not the XBee Smart Modem runs the stored Python code at startup.
Range
0 - 1
Parameter Description
0 Do not run stored Python code at startup.
1 Run stored Python code at startup.
Default
0
PY (MicroPython Command)
Interact with the XBee Smart Modem using MicroPython. PY is a command with sub-commands.
These sub-commands are arguments to PY.
PYC(Code Report)
You can store compiled code in flash using the Ctrl-F command from the MicroPython REPL; refer to
the Digi MicroPython Programming Guide. The PYC sub-command reports details of the stored code. In
Command mode, it returns three lines of text, for example:
source: 1662 bytes (hash=0xC3B3A813)
bytecode: 619 bytes (hash=0x0900DBCE)
compiled: 2017-05-09T15:49:44
The messages are:
n source: the size of the source code used to generate the bytecode and its 32-bit hash.
n bytecode:the size of bytecode stored in flash and its 32-bit hash. A size of 0 indicates that
there is no stored code.
n compiled:a compilation timestamp. A timestamp of 2000-01-01T00:00:00 indicates that the
clock was not set during compilation.
In API mode, PYC returns five 32-bit big-endian values:
n source size
n source hash
n bytecode size
n bytecode hash
n timestamp as seconds since 2000-01-01T00:00:00

Digi XBee3 XB3M1 Specifications

General

Brand	Digi
Model	XBee3 XB3M1
Category	Modem
Language	English