AT commands BLE commands
Digi XBee3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide
200
BLE commands
The following AT commands are BLE commands.
BL (Bluetooth MAC address)
The BL command reports the EUI-48 Bluetooth device address (BLEMAC address). Due to standard
XBee AT Command processing, leading zeroes are not included in the response when in command
mode.
Parameter range
N/A
Default
N/A
BT (Bluetooth enable)
The BT command enables or disables the Bluetooth functionality.
Parameter range
Bit Description
0 Bluetooth functionality is disabled.
1 Bluetooth functionality is enabled.
Default
$S (SRPSalt)
Note You should only use this command if you have already configured a password on the XBee device
and the salt corresponds to the password.
The SRP (Secure Remote Password) Salt is a 32-bit number used to create an encrypted password for
the XBee device. The $S command is used in conjunction with the $V, $W, $X, and $Y verifiers.
Together, the command and the verifiers authenticate the client for the BLE API Service without
storing the XBee password on the XBee device.
The salt is configured in the $S command. In the $V, $W, $X, and $Y verifiers, you specify the 128-byte
verifier value, where each command represents 32 bytes of the total 128-byte verifier value.
Note XBee device does not allow for 0 to be valid salt. If the value is 0, SRP is disabled and you will not
be able to authenticate using Bluetooth.
Parameter range
0 - FFFFFFFF
Default
0
To Next Page
Loading...
Need help?
General
