EATON Managed ePDUt User’s Guide S 164201xxx Rev 1 DRAFT 10−OCT−2008
11
Chapter 4 Installation and Configuration
This chapter explains how to install a ePDU and configure it for network connectivity.
Before You Begin
Before beginning the installation, perform the activities listed below:
Unpack the ePDU and Components
1. Remove the ePDU and other equipment from the box in which they were
shipped. See Package Contents" on page 3 for a complete list of the contents
of the box.
2. Compare the model and serial number of the equipment with the number on the
packing slip located on the outside of the box and make sure they match.
3. Inspect the equipment carefully. If any of the equipment is damaged or missing,
contact your Eaton service representative for assistance.
Prepare the Installation Site
1. Make sure the installation area is clean and free of extreme temperatures and
humidity.
2. Allow sufficient space around the ePDU for cabling and outlet connections.
3. Review the Safety Instructions" in Chapter 2.
Fill Out the Equipment Setup Worksheet
An Equipment Setup Worksheet is provided in Chapter 9, Appendix A. Use this
worksheet to record the model, serial number, and use of each device connected to
the ePDU.
As you add and remove devices, keep the worksheet up to date.
To Next Page
Loading...
Need help?
General
