USING THE WEB INTERFACE
EATON Managed ePDUt User’s Guide S 164201xxx Rev 1 DRAFT 10−OCT−2008
31
NOTE RMS refers to root mean square, a statistical method for measuring certain types of variables. In this
context, it gives the value of current or voltage that is equivalent to a comparable DC value.
All Outlets Control
The All Outlets Control panel at the bottom of the Home page allows you to turn all
outlets ON and OFF. Click On to turn all outlets ON, click Off to turn all outlets OFF. As
with individual outlets, you must confirm the selection before it takes effect.
Figure 34.
NOTE Users must have permission to access all outlets in order to use All Outlets Control.
Setting Up User Profiles
The ePDU is shipped with one user profile built in. This is the admin profile, which
was used for the original login. This profile has full system and outlet permissions,
and should be reserved for the system administrator. This profile cannot be modified
or deleted.
All users must have a user profile. The profile specifies a login name and password,
and contains additional (optional) information about the user. It also assigns the user
to a user group, and the user group determines the user’s system and outlet
permissions.
If you choose, you can refrain from assigning some or all users to a user group, and
instead assign their system and outlets permissions on an individual basis.
NOTE By default, multiple users can log in at the same time using the login name from the same profile.
You can change this so only one user at a time can use a specific login. This is done by selecting
Device Settings > Security and selecting the Enable Single Login Limitation check box.
To Next Page
Loading...
Need help?
General
