USING THE WEB INTERFACE
EATON Managed ePDUt User’s Guide S 164201xxx Rev 1 DRAFT 10−OCT−2008
67
Specifying the Alert Destination
The alert destination can be an email address or an SNMP trap. To specify the
destination:
1. Select Alerts, and then select Alert Destinations. The Alert Destinations page
displays (see Figure 62).
Figure 62. Alert Destinations Page
NOTE If you have not configured the ePDU SMTP, a note will appear on this page prompting you to do so
now. You cannot enter an email address until you have configured the SMTP server. Either click the SMTP
server here link that displays on this page, or select Devices Settings > SMTP Settings. See Configuring the
SMTP Settings" on page 80 for details.
2. Select the destination from the drop−down list in the Destination Type field. Your
choices are Event Log, Switch Outlets, eMail and SNMP.
3. Do one of the following:
S Event Log. This is one of the default options for Alert Destination. If you
selected this option, event entries are recorded in the event log. This
destination is built in by default, and can be neither added nor deleted.
S Switch Outlets. This is one of the default options for Alert Destinations. If you
selected this option, configured outlet is switched on, off, or cycled. This
destination is built in by default, and can be neither added or deleted.
S eMail. If you selected email, type the receiver’s email address.
S SNMP. If you selected SNMP, enter the IP address of the trap and the
community string.
4. Click Add. The destination is added.
5. To delete an alert destination, click the appropriate Delete button.
To Next Page
Loading...
Need help?
General
