Emerson FloBoss 107 User Manual

FloBoss 107 Instruction Manual
7-8 Troubleshooting Revised June-2017
84
–40C
–40F
100
0C
32F
150
130C
267F
200
267C
512F
250
408C
767F
Note: These values are approximations only. Do not use these values to
calibrate the device.
 Verify that the wiring to the RTD terminations is correct. Refer to
Chapter 4, Input and Outputs.
 Verify that the user-supplied RTD probe is not faulty. Refer to the
instructions that accompanied the RTD probe.
7.3.9 IEC 62591 Module
If you are experiencing trouble with an IEC 62591 module:
 If the module is already set up, a power cycle of the devices will
speed up the finding of the devices.
7.3.10 Network Radio Module (NRM)
If you are experiencing trouble with a Network Radio Module:
 Raise antennas above obstructions like trees or compressors. For best
communication, the antennas must have line of sight.
 Check if cable runs are too long, or if cable is of the wrong type. Less
than 3 dB of loss for the entire cable run is recommended. LMR-400
has 3.8dB of loss per 100 feet. The recommended maximum is 75
feet.
 Waterproof of all cable connections. If water gets into the cable, it can
cause high VSWR/antenna reflect power.
 Check for mismatched antennas. Avoid using the incorrect antenna
for the frequency of radio. Make sure that the antenna used is for the
frequency range of the radio.
 Mount antennas outside of metal enclosures. Antennas must have at
least 10 feet of vertical separation from other antennas.
7.4 Procedures
This section presents step-by-step produces to help you troubleshoot.

Emerson FloBoss 107 Specifications

General

Brand	Emerson
Model	FloBoss 107
Category	Controller
Language	English