Epson VT6L User Manual

Maintenance 6. Firmware Update
VT Rev.1 137
(8) Firmware and data file transfer starts. It takes several minutes to complete.
(9) The following dialog appears when transfer is completed. Click the <Next> button
to reboot the Manipulator.
(10) The following dialog appears after the Manipulator reboot. Click the <Finish>
button.
The firmware upgrade is completed.
Start EPSON RC+ 7.0 and restore the Controller settings.
For details of restoring the operating system, refer to Maintenance 5. Backup and Restore.
When you install the firmware (Ver.7.4.0.2 or later) on the controller which the firmware
(before Ver.7.4.0.2) has been installed, the following message is displayed.
When the message is displayed, re-install the firmware.

NOTE

Epson VT6L Specifications

General

Brand	Epson
Model	VT6L
Category	Robotics
Language	English