03-I 0 Auxiliary Systems
03-l 0
DISTRIBUTORLESS IGNITION SYSTEM REMOVAL AND INSTALLATION
Ignition Coil
Removal
1. Disconnect battery ground lead.
2.
Disconnect ignition coil multiplug.
PPD0003
3. Compress 2 lugs and disconnect HT leads at coil.
PPD0004
Remove four screws and detach coil assembly.
PPD0005
Installation
1. Position coil assembly, secure with three screws.
2. Connect HT leads at coil, ensuring that locking
tabs snap into position.
NOTE: HT connections at coil are marked 1 to 4. It
is important that each HT lead is connected in
correct sequence.
3.
Connect ignition coil multiplug.
4.
Connect battery ground lead. Start engine and
check coil operation.
Engine Speed (Crankshaft Position) Sensor
Removal
1. Disconnect battery ground cable.
2.
Disconnect multiplug from sensor. Remove
engine speed sensor (one screw).
CRANKSHAFT- POSITION
N605892-S2
ER
(71-l
06
LB-IN)
A23933-A
ENGINE
SPEED
SENSOR
Installation
1. Fit engine speed sensor and secure with screw.
2. Refit sensor multiplug.
3. Connect battery ground cable.
To Next Page
Loading...
Need help?
General
