02-I 3
Engine Service, 2.3L
02-I 3
2.3L ENGINE SERVICE (Continued)
/ Itern 1 NiZer 1
Description
K -
L -
M -
N -
Tighten to 40-55 Nom (29-40 Lb-Ft)
Tighten to 1 O-14 Nom (89-l 24 Lb-In)
Tighten to 20-30 Nom (15-22 Lb-Ft)
Tighten to 41-49 Nom (30-36 Lb-Ft)
Valve Cover and Gasket
Removal
1.
Remove ignition harness.
2. Snap ignition cables out of ignition coil and place
to the side.
3. Remove bolts and valve cover (6582).
4. Remove valve cover gasket (6584) from valve
cover. If necessary, remove oil filler cap (6766).
Installation
1. Clean valve cover. Clean valve cover gasket
surface on cylinder head (6049).
2. Put valve cover gasket in place on cylinder head.
3.
Install valve cover. Alternately tighten bolts to
9-13 Nom (84-120 lb-in).
4. Snap ignition wiring harness and ignition cables
back into place in brackets attached to valve
cover.
5. If removed, install oil filler cap.
6.
Start engine and check for leaks.
A239299A
Item
i B
Part
Number
6766
N805087-S2
6582
6049
6584
Description
Oil Filler Cap
Screw, M6-1 xl 5
Valve Cover
Cylinder Head
Valve Cover Gasket
Tighten Until Ratchet Click Is Heard
or Felt
Tighten to 9-13 Nom (84-120 Lb-In)
Camshaft Follower and Hydraulic Lash
Adjuster
SPECIAL SERVICE TOOL(S) REQUIRED
r
Description
I Valve Spring Compressor
I
Tool Number
I
1 T95T-6565-A
I
Removal
1.
Remove the valve cover as outlined in this
section.
2. Rotate the camshaft (6250) so the rocker arm
(6564) to be removed is on the heel of its cam.
To Next Page
Loading...
Need help?
General
