03-11
Auxiliary Systems
03-11
DISTRIBUTORLESS IGNITION SYSTEM REMOVAL AND INSTALLATION (Continued)
Engine Coolant Temperature Sensor
Removal
Installation
1. Install the sensor. Do not overtighten. Connect
1.
Disconnect battery and release cooling system
multiplug, ensuring that locking tabs snap into
bressure.
position.
2.
WAR’NING: WHEN RELEASING SYSTEM
PRESSURE, COVER CAP WITH ATHICK CLOTHTO
PREVENT COOLANT SCALDING.
Replace radiator drain plug and refill system with
correct solution. Remove rubber blanking cap on
water outlet. When coolant is evident, refit
blanking cap. Fill container to “maximum” mark
2.
Place a clean drain tray below engine under allowing time for air in system to bubble through.
radiator drain plug and remove drain plug. To
Install radiator cap.
assist draining remove radiator cap. Drain
sufficient coolant to lower the level below the
temperature sensor.
3.
Remove temperature sensor multiplug. To
remove multiplug, pull on multiplug, do not pull on
wiring.
4.
Unscrew the sensor.
3. Connect battery and start engine. Allow engine to
warm to normal operating temperature. Check
and, if necessary, add coolant.
ENGINE
COOLANT
TEMPERATURE
SENSOR
PPD0007
To Next Page
Loading...
Need help?
General
