02-34
Engine Service, 2.3L
02-34
2.3L ENGINE SERVICE (Continued)
Intake Manifold
FRONT OF ENGINE
PPDA23949-A
Item
Part
Number
6049
N605787-S52
N808163-Sl OO
9439
9424
Description
Cylinder Head
Bolt, M8-1.25 x 25 (7 places)
Stud, M8-1.25 x 1.25 x 63.7
Intake Manifold Gasket
Intake Manifold
Refer to Procedure in Text
Installation
1. Clean and inspect the mounting surfaces of the
intake manifold and the cylinder head (6049).
Both surfaces must be clean and flat.
2.
Clean and lightly oil the manifold bolt/stud
threads
3. Install a new intake manifold gasket (9439).
CYLINDER HEAD
ASSEMBLY
6049
8
4
1
5 I
B FRONT OF ENGINE
V6293-B
6.
Install the PCV valve into the oil separator. Install
the vacuum line from the ignition control module.
4. Position the intake manifold to the cylinder head.
Install four manifold upper retaining bolts/studs
7.
Connect the governor throttle control rod (if used)
finger tight.
to the carburetor throttle lever.
5. Install four remaining manifold bolts/studs.
8.
Install the choke cable bracket and the choke
Tighten all bolts/studs to 26-38 Nom (19-28 lb-ft)
cable to the choke lever on the carburetor.
following the tightening sequence. Install the
engine lifting eye.
To Next Page
Loading...
Need help?
General
