03-50
Auxiliary Systems
STARTER, PERMANENT MAGNET REMOVAL AND INSTALLATION (Continued)
03-50
BAl-i-ERY
8
#I2 GAUGE
WIRE (RED)
STARTER
CABLE
7 CAUTION: A jumper wire must not be installed
between the large round electrical terminal and
the solenoid blade terminal at the starter, to
avoid use of the # 12 wire. If done, voltage is
generated to the solenoid by the spinning starter
after release of the start key or button, causing
the starter to remain engaged, resulting in failure.
ESSF-1 IA004
TERMINAL
SOLENOID
BLADE
TERMINAL
STARTER
MOTOR
SOLENOID
-AB
PERMANENT
I
MAGNET
TERMINAL
STARTER
COVER
PPD0043
To Next Page
Loading...
Need help?
General
