FS TAP Series User Manual

TAP Series Switch Command Line Reference
11
Related Commands
show interface status
1.2 show interface
Use this command to display the configurations and statistics on all interfaces or one
interface.
Command Syntax
show interface (IF_NAME |)
IF_NAME
Specify the interface name to show.
Command Mode
Privileged EXEC
Default
None
Usage
Use this command to display the configurations and statistics on all interfaces or one
interface.
If the parameter “IF_NAME” is not specified, the command indicates that all interfaces on
this device should be displayed; otherwise only the specified interface should be displayed.
Examples
This example shows how to display the configurations and statistics of interface eth-0-1:
Switch# show interface eth-0-1
Interface eth-0-1
Interface current state: DOWN
Hardware is Port, address is 001e.0809.78a3
Bandwidth 1000000 kbits
Index 1 , Metric 1
Speed - auto , Duplex - auto , Media type is 1000BASE_T
Link speed type is autonegotiation, Link duplex type is autonegotiation

FS TAP Series Specifications

General

Brand	FS
Model	TAP Series
Category	Switch
Language	English