FS TAP Series User Manual

TAP Series Switch Command Line Reference
338
19.17 split interface
Use the command to split physic port to 10G ports or 40G ports.
Use the no form of this command to set the interface to un-split the physic port.
Command Syntax
split interface IF_NAME_E ( 10giga | 40giga )
no split interface IF_NAME_E
IF_NAME_E
Interface name
10giga
Split to 10G port
40giga
Split to 40G port
Command Mode
Global Configuration
Default
None
Usage
Need to save configuration and reboot to make this command take effect.
Examples
The following example shows how to split interface to four 10G port:
Switch(config)# split interface eth-0-34 10giga
Notice: Configuration of split interface should be writen in startup-config, and take effect at next
reload
Related Commands
reboot

FS TAP Series Specifications

General

Brand	FS
Model	TAP Series
Category	Switch
Language	English