FS TAP Series User Manual

TAP Series Switch Command Line Reference
78
6 TIMESTAMP Commands
6.1 timestamp-over-ether
Use this command to configure the TAP timestamp outer header information.
Use the no form of this command to remove the TAP timestamp configuration.
Command Syntax
timestamp-over-ether MAC_ADDR_DA MAC_ADDR_SA ETHTYPE_ID
no timestamp-over-ether
MAC_ADDR_DA
Ethernet destination MAC address
MAC_ADDR_SA
Ethernet source MAC address
ETHTYPE_ID
Ethertype in hexadecimal, range is [0x0-0xffff]
Command Mode
Global Configuration
Default
None
Usage
TAP timestamp is global configuration. TAP timestamp MUST be configured before using the
TAP groups.
This command is not supported on CTC5160 (GreatBelt) based switch.
Examples
The following example shows how to configure timestamp-over-ether

FS TAP Series Specifications

General

Brand	FS
Model	TAP Series
Category	Switch
Language	English