FS TAP Series User Manual

TAP Series Switch Command Line Reference
32
Usage
Use this command to create Flow and then enter Flow configuration mode.
Use the no form of this command to delete the flow.
If the system already has a flow with the same name, this command will enter the flow
configuration mode.
When the name is not used by any flow, this command is to create the flow and then enter
the flow configuration mode. When configured with parameter
”
type decap
”
means this
flow match tunnel decap, which flow entries can configure “inner-match” fields.
Notice: Decap only supported at CTC8096 (GoldenGate) based switch.
Examples
This example shows how to create a flow named f1 and then enter the flow configuration
mode.
Switch(config)# flow f1
Switch(config-flow-f1)#
The following example shows how to delete the flow
Switch(config)# no flow f1
Related Commands
show flow
2.5 remark
Use this command to add remarks for the flow.
Use the no form of this command to delete the remarks.
Command Syntax
remark NAME_STRING
no remark

FS TAP Series Specifications

General

Brand	FS
Model	TAP Series
Category	Switch
Language	English