TAP Series Switch Command Line Reference
Examples
The following example shows how to set console line-password specifies a hidden password
will follow:
Switch# configure terminal
Switch(config)# line console 0
Switch(config-line)# line-password 8 test
The following example shows how to unset console line-password:
Switch# configure terminal
Switch(config)# line console 0
Switch(config-line)# no line-password
Related Commands
show console
Use this command to set console sync line stop bits.
Use no form of this command to set console sync line stop bits to default value.
Command Syntax
stopbits ( 1 | 2 )
no stopbits
Command Mode
Line-CON
Default
Default is one-bit stop.