FS TAP Series User Manual

TAP Series Switch Command Line Reference
286
Usage
User cannot connect to the device via telnet and only console port is available for
management after removing the IP address.
Examples
The following example sets the management ipv4 address.
Switch(config)# management ip address 10.10.39.104/23
The following example unsets the management ipv4 address.
Switch(config)# no management ip address
Related Commands
management route gateway
17.6 management route gateway
Use this command to set the gateway on the Switch for management ip.
Use no form of this command to delete the gateway on the Switch for management ip.
Command Syntax
management route ( add |) gateway IP_ADDR
no management route gateway
add
Add a gateway address
IP_ADDR
IP address
Command Mode
Global Configuration
Default
None

FS TAP Series Specifications

General

Brand	FS
Model	TAP Series
Category	Switch
Language	English