256 Faxing
Sending a Delayed Fax
You can use the Delayed Start mode to save scanned documents and transmit them at the specified
time to take advantage of lower long distance rates.
1 Load a document(s) face up on the Automatic Document Feeder (ADF) with the top edge going
in first; or place a single document face down on the document glass and close the document
cover.
See also:
• "Loading a Source Document on the Automatic Document Feeder (ADF)" on page 249
• "Loading a Source Document on the Document Glass" on page 250
2 Press the (Fax) button.
3 Adjust the document resolution to suit your fax needs.
See also:
• "Resolution" on page 251
• "Lighten/Darken" on page 252
4 Select Delayed Start, and then press the button.
5 Select On, and then press the button.
6 Enter the start time using the numeric keypad or press the or button to select the start time,
and then press the button.
7 Select Fax to, and then press the button.
8 Select Keypad, and then press the button.
9 Enter the number of the remote fax machine using the numeric keypad, and then press the
button.
You can also use speed or group dial numbers.
See also:
• "Automatic Dialing" on page 265
10 Press the (Start) button.
When the Delayed Start mode is activated, the printer scans and stores all the documents in its
memory and sends them at the specified time. The data in the memory is cleared upon
completion of the fax transmission.
To Next Page
Loading...
Need help?
General
