Chapter 3: Programming
92 EST iO64 and iO500 Technical Reference Manual
Setting the time and date
The first step in programming the panel is setting the time and date.
You must set the time and date before auto programming or
advanced programming the panel.
Reports
Test
Control
Program
⇩
Program
Auto Program
Advanced Program
Date and Time
⇩
Enter Password
0000
⇩
Date and Time
Date 01/01/2007
Time 00:00
Daylight Savings
⇩
To set the time and date:
1. Press the Menu button.
2. Choose Program.
3. Choose Date and Time.
4. Enter your password (the minimum of a level one password is
required).
5. Enter the current date.
6. Enter the current time.
7. Choose Save.
8. Continue programming your system or press Menu to exit menu
mode.
Date and Time
Time 00:00
Daylight Savings
Save
To Next Page
Loading...
Need help?
General
