Chapter 3: Programming
144 EST iO64 and iO500 Technical Reference Manual
Network card programming
If you are using the optional Ethernet network card, you must
configure its IP address, subnet mask, and gateway so that it can
communicate on your network. Contact your network administrator
to obtain this information or use the default settings. The network
card can be used to send event information to a central monitoring
station, download to the panel from the configuration utility, or
upload and view system reports using the configuration utility.
Network card default settings:
IP: 192.168.001.003
Mask: 255.255.255.000
Gateway: 000.000.000.000
Panel Configuration
IP 192.168.001.003
MSK 255.255.255.000
GWY 000.000.000.000
⇩
Panel Configuration
MSK 255.255.255.000
GWY 000.000.000.000
Save
To program the network card:
1. Access the panel configuration options menu. See "Panel
configuration options."
2. Choose IP.
3. Enter the network card's IP address.
4. Choose MSK.
5. Enter the network card's subnet mask number.
6. Choose GWY.
7. Enter the network card's gateway number.
8. Choose Save.
9. Continue programming your system or press Menu to exit menu
mode.
To Next Page
Loading...
Need help?
General
