Chapter 1: System operation
EST iO64 and iO500 Technical Reference Manual 33
Disabling a device
Devices can be disabled using the front panel. A disabled device is
still functioning, but does not report an off-normal condition to the
panel while it is disabled. When a device is disabled:
• The common Disable LED turns on
• A message indicating the device that is disabled is displayed on
the LCD display
• The common Trouble LED flashes and the panel goes into a
trouble state
• The common trouble relay changes state
• The disabled points and active points counters on the LCD
display increment
Resetting the panel has no effect on a disabled device, but removing
all power from the panel clears the disable and enables the device.
Note: If the device you are disabling is active, a warning message is
displayed.
Reports
Test
Control
Program
⇩
Enter Password
0000
⇩
Control
Enable/Disable
Activate/Restore
⇩
Enable/Disable
Device
Zone
Panel Event
⇩
Device
Loop 01<>
To disable a device:
1. Press the Menu button.
2. Choose Control.
3. Enter your password (the minimum of a level one password is
required).
4. Choose Enable/Disable.
5. Choose Device.
6. Choose the loop the device is on.
Note: If your panel only has one loop, the loop selection screen
does not display. Go to the next step.
7. Enter the device ID for the device that you want to disable.
8. Press Enter.
9. If the device is active, acknowledge the warning message by
selecting Continue to disable the device or Cancel to exit.
The device is disabled and a message indicating that the device
is disabled is displayed on the LCD.
10. Press Cancel to return to the previous menu.
— or —
⇩
To Next Page
Loading...
Need help?
General
