Chapter 1: System operation
EST iO64 and iO500 Technical Reference Manual 17
Event ID numbers and descriptions
Event ID Event description
000 Loop 1 initialization: Loop 1 is starting up
001 Loop 1 fault: A short or open was detected on loop 1
affecting the communications between the panel and the
devices on the loop
002 Loop 1 map fault: A mapping fault was detected on loop 1
while the panel was mapping the devices
003 Loop 1 card fault: The loop 1 card is not present or it is not
working properly
004 Loop 1 uncfgrd alarm: A device on loop 1 that is not
programmed went into alarm
005 Loop 1 uncfgrd trouble: A device on loop 1 that is not
programmed went into trouble
006 Loop 1 map mismatch: The loop 1 map in RAM and the
loop 1 map in the database do not match
007 Loop 1 over limits: There are too many devices on loop 1
008 Loop 1 device 000: A device on loop 1 has an address set
to zero
009 Loop 1 mapping: Loop 1 is mapping its devices
010 Loop 2 initialization: Loop 2 is starting up
011 Loop 2 fault: A short or open was detected on loop 2
affecting the communications between the panel and the
devices on the loop
012 Loop 2 map fault: A mapping fault was detected on loop 2
while the panel was mapping the devices
013 Loop 2 card fault: The loop 2 card is not present or it is not
working properly
014 Loop 2 uncfgrd alarm: A device on loop 2 that is not
programmed went into alarm
015 Loop 2 uncfgrd trouble: A device on loop 2 that is not
programmed went into trouble
016 Loop 2 map mismatch: The loop 2 map in RAM and the
loop 2 map in the database do not match
017 Loop 2 over limits: There are too many devices on loop 2
018 Loop 2 device 000: A device on loop 2 has an address set
to zero
019 Loop 2 mapping: Loop 2 is mapping its devices
020 System startup: The control panel is starting up
021 Program mode: The control panel is in program mode
022 Reset: The control panel is resetting
To Next Page
Loading...
Need help?
General
