Chapter 4: Reports
EST iO64 and iO500 Technical Reference Manual 183
Internal Fault report
The Internal Fault report displays information about an internal fault
event (event ID 48) that took place on your system. The report
contains important information for technical support when you are
troubleshooting the internal fault event and should typically only be
run when you are asked to do so by a technical support
representative.
Notes
• You must have a printer connected to your panel to print a
report.
• Requesting a report while another report is being printed or
displayed on the LCD display stops the current report (even if it
has not finished) and starts the new report that you requested.
Reports
Test
Control
Program
⇩
Reports
Device Details
Diagnostics
Int. Fault
⇩
To view an Internal Fault report:
1. Press the Menu button.
2. Choose Reports.
3. Choose Int. Fault.
4. Choose either:
LCD: The report is displayed on the LCD display.
— or —
Printer: The report is printed on the connected printer. If you do
not have a printer, this option is not available.
5. If you selected LCD, when finished viewing the report, press
Cancel twice to return to the reports menu.
6. Choose another report to view or to exit menu mode, press the
Menu button.
LCD
Printer
To Next Page
Loading...
Need help?
General
