GE Revolution CT User Manual

3.1.4.2 Batch Options
The Batch Options change depending on the type of series being used in the reformat.
Table 2: Oblique settings
For this setting:
Select or set:
Type This setting is read-only (set in the Protocol settings)
Number of images Set the number of images to include in the reformat. This num‐
ber updates based on slice thickness, slice interval, and the start
and end locations.
Slice thickness
Set the slice thickness.
Interval Set the slice interval.
FOV Set the field of view. The value is specified in centimeters (cm).
Rendering Mode Select the rendering mode.
Table 3: Rotate settings
For this setting: Select or set:
Type This setting is read-only (set in the Protocol settings)
Number of images Set the number of images. This value updates based on slice
thickness, angle between images and start and end location.
Angle between images Set the angle between images.
Slice Thickness Set the slice thickness.
FOV Set the field of view
Rendering Mode Select the rendering mode.
Preview tool
Before you save or print a batch, you can preview what the batch will look like using the Preview
tool in the Batch Options section of the
Reformat Settings panel.
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
424 3 Direct Multi Planar Reformat (DMPR)

GE Revolution CT Specifications

General

Brand	GE
Model	Revolution CT
Category	Medical Equipment
Language	English