GE Revolution CT User Manual

○
If the test login was successful and you’re satisfied with the First Name , Last Name , or
any Group Memberships information, the enterprise directory server is configured
properly.
10.
Click [Apply Configuration] to accept the configuration changes.
Click [Restore Configuration] to undo any changes not yet applied.
2.18 Manual configuration
Use this information to connect to an enterprise directory server other than MSAD, Novell
eDirectory, or any other system that has a custom configuration. The following LDAP definitions
are for configuration properties that may need to be manually selected.
Field
Description
Format
Set to
domain or dn .
•
domain is the MSAD way of doing LDAP authentication (<userId>@<realm name>).
•
dn
is the eDirectory way of doing LDAP authentication; most other directory servers use (log-
inAttribute=<userId>,<ldap base dn>). If you are connecting to a non-MSAD directo‐
ry server, you will more than likely use dn .
DN
•
The LDAP base DN of the LDAP server to which you are connecting.
•
Typically this is the fully qualified domain name separated by clusters of DC=.
•
For example, if the fully qualified domain name of the directory server is example.com, it is
likely that the DN is DC=example,DC=com.
Login Attribute
•
The LDAP attribute to be used for the unique user identifier; the username to login.
•
Set to the unique identifier your server uses.
○
On MSAD it is: sAMAccountName
○
On eDirectory, it is typically:
cn
First Name Attribute The LDAP attribute used for the user's first name.
Last Name Attribute The LDAP attribute used for the user's last name.
Group Attribute
•
The LDAP attribute used to find group memberships for the user.
•
On MSAD, it is
memberOf .
NOTE: EA3 finds all instances of this attribute (not just the first, like it does for other attrib‐
utes). If a user belongs to more than one group, EA3 finds all memberships.
NOTE: Regarding LDAP parameter configurations, EA3 finds the first instance of the
configured attribute for a user, except for Group Membership . If you configure the
First Name Attribute to be an attribute listed multiple times, EA3 assumes the first one
found during an LDAP query is the correct
First Name . For Group Membership , EA3
finds all instances of that attribute.
Save changes
•
No changes are saved to EA3 on a tab unless you click [Apply Configuration] before you
navigate to another tab, or click [Confirmation]. If there is more than one [Apply
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
Chapter 19 Access Controls 611

GE Revolution CT Specifications

General

Brand	GE
Model	Revolution CT
Category	Medical Equipment
Language	English