Vehicle care 219
2. Push the bulb into the socket
slightly and rotate anticlockwise,
to remove.
3. Insert a new bulb.
4. Place the bulb into the socket
and rotate clockwise.
5. Replace the bulb holder and
rotate clockwise to engage.
6. Check lamp operation.
Tail lamps, turn signals,
stop lamps and reverse
lamps
Hatch shown
1. Unscrew both screws.
2. Hold both sides of the tail lamp
assembly.
3. Pull rearwards to disengage
the two locator pins from the
outer panel.
• Tail/stop lamp (1)
• Turn signal lamp (2)
• Reverse lamp (3)
To Next Page
Loading...
Need help?
General
