NOTICE
If a CPU socket has bent pins or contains foreign matter, or the bonding pad is damaged,
stop the installation and contact Huawei technical support.
3. Horizontally hold the CPU and heat sink to align pin 1 of the CPU and heat sink with Pin
1 of the notched corner on the bracket, and gradually place the CPU and heat sink on the
bracket along the guide sleeves. See Figure 6-28.
NOTICE
Keep the assembly horizontal to avoid damaging socket pins.
4. Use a T20 torx screwdriver to tighten the two screws on the heat sink (the pair of screws
that correspond to 1 on the heat sink label). See (3) in Figure 6-28. Then tighten the four
screws in the diagonal direction on the heat sink (the two pairs of screws that correspond
to 2 on the heat sink label). See (4) in Figure 6-28.
Step 11 Install the cover. For details, see Installing the Cover of a G530 V2.
Step 12 Install the G530 V2. For details, see 4.4.4 Installing a G530 V2.
Step 13 Power on G530 V2. For details, see 3.2 Powering On the Compute Node.
----End
6.4.3 DIMM
NOTICE
The server does not support mixed use of different types of DIMMs. Mixed use of the
DIMMs may cause the BIOS initialization of the G530 V2 to fail.
The memory subsystem supports LRDIMMs or RDIMMs.
l RDIMMs support memory address parity check.
l LRDIMMs support a higher density than single-rank and dual-rank RDIMMs. This
increases system memory capacity and bandwidth.
6.4.3.1 DIMM and CPU Compatibility
Observe the following rules when configuring DIMMs:
l The G530 V2 supports 8 GB, 16 GB, 32 GB, 64 GB, or 128 GB DIMMs. A G530 V2
that is fully configured with DIMMs provides a maximum capacity of 3 TB.
l The maximum number of DIMMs that can be installed on the G530 V2 depends on the
number of CPUs installed, DIMM type, and number of ranks. See Table 6-3.
FusionServer G5500 Server
User Guide
6 Optional Part Installation
Issue 02 (2017-12-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
148
To Next Page
Loading...
Need help?
General
Weight and Dimensions
