QVM6800+ Installation and Operation Manual 11
Chapter 3
Using ZConfigurator
Overview
This chapter describes how to operate the QVM6800+ series modules using ZConfigurator.
The following topics are discussed in this chapter:
• “Operating Notes” on page 11
• “Adding a License Key” on page 11
• “Connecting to a Module for the First Time” on page 12
• “Working with Cascade Systems” on page 14
• “Getting Started with ZConfigurator” on page 22
• “Configuring QVM6800+ Settings” on page 27
Operating Notes
When you set the control parameters on QVM6800+ modules observe the following:
• If changes are made to certain parameters, other related parameters may also be affected.
• When a parameter is changed, the effect is immediate. However, the module requires a few
seconds to save changes. Once saved, new settings will be restored if the module loses
power and is restarted.
• Terminate any unused coaxial output connectors with a 75Ω connector.
Adding a License Key
To use new features such as 3G outputs and cascades, appropriate licences should be purchased.
License keys for options that may apply to the QVM6800+ series may be added using
ZConfigurator.
See “Licensing” on page 41.
Part numbers to order licenses are shown in the table Table 1-2, “QVM6800+ part numbers” on
page 6.
For assistance with a license key, or to purchase a license key, contact your Sales
representative.
To Next Page
Loading...
Need help?
General
