QVM6800+ Installation and Operation Manual 37
Chapter 3: Using ZConfigurator
Using an LTC source - select LTC to lock to external Longitudinal Time Code. The Horita
option is not available for this multiviewer.
Using SNMP Agents
The Simple Network Management Protocol (SNMP) is used to allow network attached
multiviewers to be monitored remotely for alarms and other conditions that might require
administrative attention.
An SNMP agent receives requests from and sends responses to ZConfigurator when an event,
such as a video or audio alarm occurs. To use an SNMP agent check the Activate SNMP Agent
box and enter an appropriate IP address and subnet mask.
To Next Page
Loading...
Need help?
General
