From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document Library
TRANSMITTING
SELECTING
OUTPUT
POWER
It's wise, and required by law, to select the lowest
power that allows reliable communication. This saves
battery power which extends battery life, and lowers the
risk of interfering with others on the band.
1 Press [BAND] to select the Operating band.
2 Press [LOW] to select the transmit power you
require.
• Each time this key is pressed, the transmit output
power changes as below. The default is High
pOW€!
f.
L
"HI"--·
"LO"
--
"EL"
J
Output
Power
(approx.)
Batteries
VHF
Band
UHF
Band
HI
LO
El
HI
I
LO
EL
PB-30 1.5 w 0.5 w
30 mW[1.5 W 0.5 w
30mW
PB-32/33
2.7W
0.5W
30mW
2.0 w
0.5W
30mW
PB-34 5.0 w
0.5W
30mW
5.0W
0.5W
30mW
"
···~
Alkaline 2.0 w
0.5W
30mW
1.5 w
0.5 w
30mW
Note:
•
The
transmit output
power
cannot be changed while transmitting.
•
The
horizontal bars that appear on the Display while transmitting
indicate the relative battery level.
PTT
SWITCH
When ready
to
begin transmitting, press and hold [PTT]
and speak in a normal tone of voice holding the dual
bander about 5 em
(2
in.) from your mouth. Speaking
too close to the microphone, or too loudly, may
increase distortion and reduce intelligibility of your
signal at the receiving station. Release
[PTT] to return
to the Receive mode.
The RX/TX indicator for the selected Operating band
lights
red
while you are transmitting.
21
To Next Page
Loading...
Need help?
General
