From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document Library
CONVENTIONS
FOLLOWED
IN
THIS
MANUAL
The writing conventions described below have been
followed to simplify instructions and avoid unnecessary
repetition. This format
is
less confusing for the reader.
Reviewing the following information now will reduce
your learning period. That means less time will
be
spent reading this manual; more time will
be
available
for operating.
Several of the keys have multiple functions and,
therefore, more than one key label. Procedures
in
this
manual use the key label that applies to the procedure
being executed. For example, when selecting the
Reverse function, the procedure refers
to
the [REV]
key. When using the same key for the Frequency Step
function, the procedure refers
to
the [STEP] key.
Note:
+ Basic procedures are numbered sequentially
to
guide you step-
by-step. Additional information pertaining
to
a step, but not
essential to complete the procedure,
is
provided
in
bulle ted form
following
many
steps for further guidance.
+ Most procedures require that you enter a final key stroke that acts
as a terminator for the procedure. You can,
if
you prefer, wait for
approximately
10
seconds rather than make this final entry.
•
Guide
Function
Identification
2
I
GUIDE
FUNCTION
• The Section Title
is
shaded as shown above for
functions included
in
the Guide (Help) Menu
on
the dual bander.
•
Key
Stroke
Conventions
Instruction
Press
[KEY].
------
Press
[KEY1]+[KEY2].
Press
[KEY1], [KEY2].
Press
[KEY]+ POWER ON.
Press
[KEY1]+[KEY2]+
POWER ON.
Press
[KEY]
(1
s).
What
To
Do
Press and release KEY.
Press and hold
KEY1
down, then press KEY2.
Press KEY1 momentarily,
release
KEY1, then press
KEY2.
With dual bander power
OFF, press and hold
KEY, then switch
ON
the
dual bander power.
With the dual bander
power OFF, press and
hold both
KEY1 and
KEY2 down, then switch
ON the dual bander
power.
Press and hold
KEY until
the function begins.
To Next Page
Loading...
Need help?
General
