From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document Library
frequency from a split memory channel or split
Call channel
is
not stored.
• If the memory channel selected
in
the
previous step already contained data, the new
data overwrites the previous data.
The previous mode is restored.
I•
Split
Memory
Channels
24
1 After storing the receive frequency using
"Simplex Memory Channels" {page 23}, select
the desired transmit frequency.
2 Press [F).
3 Turn
the ENC control to select the memory
channel containing the receive frequency.
4 Press [PTT]+[MR IN].
• The transmit frequency
is
stored and the
previous mode
is
restored.
If the memory channel selected does not
contain a receive frequency, your dual bander
beeps and restores the previous mode.
• Associated data such as Tone
status/frequency, frequency step, and DTSS
status/code are not overwritten. However,
Transmit Offset status and Reverse status are
erased.
RECALLING
MEMORY
CHANNELS
•
Using
the
ENC
Control
1 Press [BAND]
to
select the Operating band.
2 Press [MR].
• The memory channel used last is recalled.
• If
all
memory channels are empty, your dual
bander beeps and Memory Recall is not
selected.
3 Turn the ENC control to select the desired
memory channel.
• Clockwise: Increases the channel number.
• Counterclockwise: Decreases the channel
number.
•
Using
the
Keypad
1 Press [BAND]
to
select the Operating band.
2 Press [MR].
• The memory channel used last is recalled.
3 Enter a 2-digit number (00 to 79)
to
select the
desired memory channel.
To Next Page
Loading...
Need help?
General
