Kenwood TH-79E - Initializing Memory; VFO Reset (Partial Reset); All Reset

From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document Library
INITIALIZING MEMORY
If your dual bander seems to be malfunctioning,
initializing the memory may resolve the problem.
Remember that initializing the memory channels
requires that you re-enter any memory channel data
again after the reset if you wish
to use those channels.
On the other hand, if you want to erase all data from all
channels, initialization is a quick way to do this.
Note: Memory initialization is not possible if the Channel Display or
Key Lock function is ON.
Version
VHF Defaults
-
I• VFO Reset (Partial Reset)
1 Press [VFO]+ POWER ON.
• "VFO Reset? Press VFO" appears.
2 Press [VFO].
I• All Reset (Full Reset)
1 Press [F]+ POWER ON.
• "All Reset? Press F" appears.
2 Press [F].
UHF Defaults ·
----
.
. VFO Freq.
Freq.
Step Tone Freq .
VFO Freq.
i
Freq. Step . Tone Freq.
Canada
144.000 MHz
5kHz 88.5 Hz 440.000 MHz
25kHz 88.5 Hz
U.S.A.
l
r--
I
Europe
144.000 MHz
12.5 kHz 1750Hz
I
430.000 MHz
25kHz
1750Hz
···-
General 144.000 MHz 12.5 kHz 88.5 Hz 430.000 MHz 25kHz
88.5 Hz
30
··-