From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document Library
STORING
PAGE
CODES
1 Press [BAND] to select the Operating band.
2 Press
[F], [PAG] to switch ON the Page function.
Ill
PM>
llD
145.
(150
440.
OD~)
3 Press [F], [PAG CODE] to activate Code Select.
-
PAG
mpo:---
440.0[1[1
4 Turn the
ENC
control to select
Page,
memory
A.
5 Enter your Station code (000 to 999) using the
numeric keys.
Ill
PM>
mpi=J:111
44~~1.
000
6 Select Page memory 1 to 6 by turning the
ENC
control.
7 Using the numeric keys, enter a 3-dligit Group code
or individual Station code.
8 To store addiltional Page codes, repeat Steps 6
and
7.
9 Press [CLR] to exit Code Select.
You
can immediately use the code that was stored or
selected last.
CALLING
The squelch must be closed {page
16}
on both bands
before beginning! this procedure.
1 Press [BANCI] to select the Operating band.
2 Tune to the prearranged frequency.
3 Press [F], [PAG] to switch ON the Page function.
4 Press [F], [PAG CODE] to select Code Select.
5 Turn the ENG control to select the Page memory
where the desired Group code or individual
Station code
lhas
been stored.
• If you have not stored the desired Page code yet,
select memory 0 and store the Page code now.
6 Press and hold [PTT], then call the other station
after the
code1
transmission completes.
Note:
• Page
may
not function in the following situations:
Page is switched ON for both the VHF
and
UHF bands.
The
other station is using a battery saver function.
A repeater ID and the Page code are received
simultaneously.
51
To Next Page
Loading...
Need help?
General
