From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document Library
Note:
• DTSS may
not
function
in
the following situations:
OTSS is switched ON for both the VHF
and
UHF bands.
The
other station is using a battery saver function.
A repeater
10
and
the DTSS code are received
simultaneously.
If
difficulty is experienced in these cases, press [MR] while still
holding
[PTT]
down to resend the code. Alternatively, release
[PTT] then press
[PTT]
again. Remember
to
switch ON
the
DT$$
function in advance.
• When
[F], [DTSS} is pressed with Page ON, Page
is
automatically switched OFF,
and
DTSS is switched ON.
• Both OTSS status
and
a DTSS code can
be
stored
in
a memory
channel
or
the Call channel. Further, when recalling either a
memory channel
or
the Call channel with DTSS status
ON
while
using the
VFO
with Page switched ON, Page is given priority
and
the OTSS status switches OFF.
•
The
microphone is inhibited while the OTSS code is transmitted.
• It's advisable to switch OFF the Battery Saver when you
use
DTS$.
+ If DTSS
and
Tone Alert are ON, there is
no
speaker output
except the alarm tone even
if
a signal is received with the correct
DTSScode.
DTSS
AND
REPEATERS
Pressing [PTT] transmits the DTSS signal after a short
delay. This delay helps avoid losing DTSS data when
using repeaters with long response times that may miss
receiving a portion of the DTSS code.
The delay time is 350 ms during simplex operation.
When using a transmit offset or a split frequency, you
can select either
350
ms (default) or 550 ms.
1 Press [MENU].
2
Turn the
ENC:
control to select "CSQL Delay" (8).
m
DT
Cllr:Cf:)L
[:.;:::.1.=
....
_,_,,,
-
_,_
.-.
C•
3 Press [SET] to toggle between "350" ms and
"550" ms.
4 Press [MENU] to exit.
Note: DTSS cannot be used with some repeaters. Also, DTSS may
not function
if
a repeater
10
and
the DTSS code are received
simultaneously. Press [MR} while still holding {PTT] down.
or
press
[PTT} again
to
re-transmit the DTSS code.
49
To Next Page
Loading...
Need help?
General
