Kenwood TH-79E User Manual

From The N3UJJ.COM Document LibraryFrom The N3UJJ.COM Document Library
SELECTING OFFSET VALUES MANUALLY
1 Press [MENU].
2 Turn the ENC control to select "VHF Shift" (11) or
"UHF Shift" (12).
r•
en UHF 5h i ft.
00.60 11
r•
CDI_IHF Shift
05.00 12
3 Press [SET].
r•
CD·-- I--t
.:11::' -==-·-· -·
DO. 6~)
4 Turn the ENC control to select an offset value. The
control selects in 50 kHz steps.
• Select
an offset that places the transmit
frequency within the transmit range.
5 Press [SET] to store the selected value.
6 Press
[MENU] to exit to the previous mode.
Note:
• It is not possible to set different offset values for VFO mode and
the memory channels.
• The new manually selected value will be used even
if Automatic
Offset is switched
ON.
TH-79E: The offset can be changed from the default 1.6 MHz value;
however, the 7.6 MHz value is
not configurable.
REVERSE FUNCTION
Reverse allows you to manually check the signal
strength of a station accessing a repeater by switching
your dual bander's transmit and receive frequencies on
the selected band.
Press
[REV] to toggle the function ON or OFF.
• The receive frequency and transmit frequency
on
the selected band are exchanged. "R" appears
when the function is ON. The default is OFF.
•
If reversal would place the receive frequency outside
the receiver frequency range,
an error beep sounds
when
[REV] is pressed. No reversal occurs.
If the transmit frequency would go out of the
transmitter frequency range if
[PTT] were pressed,
then pressing
[PTT] causes an error beep and
Receive
is selected.
Reverse cannot be activated while
[PTT] is held
down.
• Automatic Offset cannot be used while Reverse is
ON.
33

Kenwood TH-79E Specifications

General

Brand	Kenwood
Model	TH-79E
Category	Two-Way Radio
Language	English