Kubota B1620 Workshop Manual

TRANSMISSION
B1220, B1620, B1820, WSM
3-S4
(EU)
4. DISASSEMBLING AND SERVICING
[1] PREPARATION
(1) Separating Engine from Clutch Housing
Bonnet, Front Grille, Side Cover and Battery Negative Cable
1. Open the bonnet (3) and remove the front grille (1).
2. Disconnect the negative cable (2).
3. Disconnect the head light connectors, horn connectors and
remove the bonnet (3).
4. Remove the side covers (4).
NOTE
• When disconnecting the battery cables, disconnect the
negative cable first. When connecting, positive cable first.
9Y1210272ENS0001US0
Draining Coolant
CAUTION
• Never open the radiator cap while operating or immediately
after stopping. Otherwise, hot water will spout out from the
radiator. Wait for more than ten minutes to cool the
radiator, before opening the cap.
1. Loosen the drain cock (3) from the radiator hose to drain
coolant.
2. Remove the radiator cap (1) to drain coolant completely.
9Y1210272ENS0002US0
(1) Front Grille
(2) Battery Negative Cable
(3) Bonnet
(4) Side Cover
Coolant
(with recovery tank)
Capacity
3.4 L
3.6 U.S.qts
3.0 Imp.qts
(1) Radiator Cap
(2) Recovery Tank
(3) Drain Cock
KiSC issued 07, 2011 A

Kubota B1620 Specifications

General

Engine Type	Diesel
Cylinders	3
Fuel Type	Diesel
Hydraulic System Type	Open center
Drive	4WD
3-Point Hitch Category	Category I